![]() You’re now logged in and will be able to make changes to your NETGEAR Nighthawk router’s settings. Now type “Admin” for the user name and “password” for the password.This is the default IP address for the router. Type 192.168.0.160 in your computer’s web browser’s address bar.Set up a static IP address in the 192.168.0.x subnet and wait until the LEDs blink pattern remains the same and doesn’t change.Open the LAN you created for accessing the router.For Windows users, open “Network and Sharing Center.” For Mac users, open the “Network Panel.”.This usually takes approximately 15 seconds. Using a straightened paperclip or similar device, push the “Reset” button.Turn on the router and wait until the power LED is flashing and the other LEDs are off.Connect a computer or laptop to the router using an Ethernet cable.To accomplish this using direct access, meaning hardwiring directly to your router, follow the instructions below. It’s not a difficult process, and can be done in a few straightforward steps. You’re going to need the default password to access your router’s settings. What Is the Default Password for NETGEAR Nighthawk Direct Access We’ll discuss the default passwords, and also how to log in to your Nighthawk via direct access and Wi-Fi. If you’ve forgotten what your NETGEAR Nighthawk router’s password is, this article will give you all the information you’ll need to get back into your router’s settings to make necessary changes. Fortunately, you can log in to your router using NETGEAR’s default password. You won’t be able to log in to your router’s settings without it, and you need to access its settings to make some adjustments. Unfortunately, you’ve forgotten the password. For more information check out our article on setting up Circle on NETGEAR, particularly the sections on "Setting up your account" and everything following.So, you have a NETGEAR Nighthawk router and need to adjust some of its settings. Download the Circle app from the iOS App Store or from the Android Play Store and then open it up while connected to your NETGEAR router's Wi-Fi network to begin setting up your Circle parental controls. Now that you've updated your router firmware and enabled Circle on NETGEAR you can set up Circle 1st generation. Then reopen it and the option will be there!) Setting up Circle on NETGEAR (Using Android and not getting the message to "Pair New Circle"? Tap the back button and then exit the Circle app. Enabling Circle on NETGEAR from the app is as easy as tapping "Pair New Circle" and then while on your NETGEAR WiFi tap the Circle on NETGEAR set up option. The links to download the Circle app displays.Īre you looking to set up Circle on your NETGEAR router and already have a Circle Home device? Before you set up Circle on NETGEAR make sure you've turned off your Circle Home device. Note: You can only enable one parental controls service. Move the slider labelled "Disabled" next to Circle 1st generation to enable Circle. ![]() The parental controls home page will display.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |